Service manual
13
Service Manual for Flexible Batch Broiler Units
CONVEYOR DRIVE MOTOR ASSEMBLY
The Conveyor Drive Motor Assembly is located in
the lower front of the broiler at the discharge end. The
motor drives the Conveyor by use of a drive chain.
WARNING
DISCONNECT THE ELECTRICAL POWER
TO THE BROILER AND FOLLOW
LOCKOUT / TAGOUT PROCEDURES.
1. Remove the Conveyor Drive Motor Cover. Refer to
the COVERS and PANELS section of the manual.
2. Disconnect wires to motor.
3. Remove Discharge Access Panel. Refer to the
COVERS and PANELS section of the manual.
4. Remove four screws securing motor to mounting
plate and remove motor.
5. Raise motor mounting plate to disengage drive
chain from motor pulley.
6. Remove sprocket from motor shaft. Sprocket is
secured to motor shaft by two set screws.
7. Reverse procedure to install a new motor. Ensure
that one of the sprocket set screws is tightened to
the at side of the motor shaft.
NOTE: When installing the new motor, be sure to
engage the chain on the motor sprocket. Adjust the
tension on the chain to allow 3/16″ chain deection,
as described in the procedure DRIVE CHAIN
DEFLECTION ADJUSTMENT in the ADJUSTMENT
Section, before tightening the motor mounting plate
screws.
COMPONENT REMOVAL
Motor
Assembly
Screws
Motor
Mounting
Plate
Conveyor Drive Motor Assembly
Chain
Motor
Sprocket
Motor Sprocket and Drive Chain