Specifications

03-TM-0037 REV 16 Page 13 of 24
Figure 10. Installation of N30A29
Series Mounting Kit and Beacon
D. Insert the beacon into the mounting cradle
with the water switch facing forward and/or
downward with reference to the aircraft. Rotate
the beacon in the mount so that the beacon
replacement date can be read. See Figure 10.
E. Screw securing plate in place with the set of
furnished screws and washers. Tighten until the
securing plate makes contact with the frame in
the area of the screws, with approximately 15 to
20 inch-pounds torque.
F. Perform the Operational Test outlined in
Section IV.
2.9.INSTALLATIONPROCEDURES FOR
THE DK130/DK140AND THE N30A21A
MOUNTINGKIT.
2.9.1. GENERAL. Space limitations sometimes
require the use of the strap-type N30A21A Mount-
ing Kit. Where a choice exists, horizontal mount-
ing with switch forward is best. If vertical mount-
ing is employed, mount switch down to reduce
accumulation of grease, dirt, and water on the
switch end of the beacon.
Figure 11. Mounting Hole Tem-
plate for N30A21A Mounting Kit
C. Test the beacon as outlined in Section IV to
insure operation prior to installation.
D. Slip the retainer straps of the mounting kit
over the ends of the beacon. See Figures 13 and
14.
2.9.2. MOUNTING PROCEDURE.
A. Lay out four holes as shown in Figure 11. Po-
sitionmountingkitcarefullytoavoidinterferencewith
other structures. Observethe clearances required as
shown in Figures 11 and 12, and in established tool
andmaintenanceclearances.
B. Drill the four 0.272 inch (0.691 cm) (“I” drill)
holes in the mounting surface as shown in Figure
11.
B. Make sure that the beacon case and water
switch, are free of grease or film. If in doubt,
wipe cleanwithmilddetergent
C.Test the beacon as outlined in Section IVto
insure operation prior to installation.