User guide

Assigning a Pager Number to a Staff Member (MENU, 5, 5)
This menu selection allows you to assign a pager number to a staff member.
Notes:
•
If your system has version 4.XX video displays, use the video display to perform
this function instead of the base master.
•
If your system has version 5.XX video displays, no assignment functions can be
performed using the base master or the video display software. ProCare 6000
Systems with 5.XX video displays use MatchMaker ip software to assign pagers to
staff. See the MatchMaker ip User Guide.
1. Press MENU.
2. Press 5 to select Pocket Page = 5.
3. Press 5 to select Assign Pager# = 5. Figure 3-26 appears:
4. Enter the ID number of the staff whose pager assignment you wish to change. If the
number is shorter than the number of spaces in the display, press *ANS. “Waiting for
Data” appears, then “OldPager#,” then a prompt for the new pager (Figure 3-27 on
page 3-25).
Note:
You can review the staff number and the old pager number by pressing VOL up.
Then press VOL down to return to Figure 3-27 on page 3-25 before proceeding.
5. Enter the new pager number and press *ANS.
6. “Waiting for Data” and “Waiting for Resp” appear briefly, then the base master
sounds an acceptance tone and returns to Figure 3-26.
Note:
If “OwnerOut” appears, see page 2-23.
7. Repeat steps 4 through 6 to assign pagers to other staff members.
8. Press #CNCL repeatedly to exit the menu and return to the normal display. If you do
not, the base master automatically exits the menu after a programmed interval.
3-24 ProCare 6000 Operation Manual
Performing Pocket Page Functions (MENU, 5)
Staff # > _ _ _ _
Figure 3-26: Assigning a Pager Number to a Staff Member