User guide

Paging Primary Staff (MENU, 5, 1)
Follow these instructions to page the primary staff member assigned to a selected station,
and transmit the station number and an optional two-digit coded message relating to that
patient.
Notes:
•
If your system has version 4.XX video displays, use the video display to perform
this function instead of the base master.
•
If your system has version 5.XX video displays, no pocket paging functions can be
performed using the base master or the video display software. ProCare 6000
Systems with 5.XX video displays use MessageMaker ip™ software to page staff.
See the MessageMaker ip User Guide.
1. Connect to the station either by answering their call or by calling them. (See pages
2-2 and 2-3, and pages 2-4 and 2-5.)
2. Press MENU.
3. Press 5 to select Pocket Page = 5.
4. Press 1 to select Page Bed Prim = 1.
Figure 2-11 appears, showing the station you are connected to:
5. Enter the two-digit number of the desired pager message. (See Pocket Pager
Messages on page 2-13.) To page the primary staff to that station without sending a
message, press *ANS.
a. “Waiting for Resp” (response) appears briefly.
b. The page (station number and optional message) is sent to the primary staff.
c. The call reappears in the display followed by TALK.
6. Press #CNCL or replace the handset to end the call.
ProCare 6000 Operation Manual 2-9
Sending a Pocket Page While Connected to a Call
Msg - > 1022 _ _
Figure 2-11: Message Display Prompt