User guide

Silencing Incoming Call Tones at a Monitoring Station
Press the monitoring station’s CANCEL button to silence the tone for a current incoming
call. When you do, this happens:
•
The tone ceases.
•
The station’s CANCEL LED flashes.
•
The LED in the selected presence button continues to flash, if present.
•
The SYSTEM MONITOR LED continues to flash.
You can manually resume the call tone by pressing the CANCEL button again.
Note:
The tone will also resume when another call occurs, or after five minutes elapse
(default setting).
Canceling System Monitor
To cancel the system monitor function from a particular station, either press the SYS
-
TEM MONITOR button on the monitoring station, or remove all registered presences
from the station. (See Removing a Registered Presence on page 4-11.) When you do, this
happens:
•
The station’s SYSTEM MONITOR LED extinguishes.
• The illuminated staff presence button extinguishes, if present.
•
The associated corridor light extinguishes.
Note:
The system monitor function cannot be canceled on staff/duty stations configured as duty
stations.
A-10 Appendix: Four-Gang Station Operations
Basic Station Operations
CALL
CODE
BLUE
STAFF
EMERG
SECRECY
CANCEL
SYSTEM
MONITOR
Figure A-7: Staff/Duty Station (Model 4A2395A)