User guide

Placing a Call from a Telephone
1. Lift the telephone handset.
2. Enter the Telco extension number. (See the extensions on page 5-1.) A basic
telephone ring and a short chirp confirm that you have accessed the Telco. (If the
Telco is in use you will hear a busy signal.)
3. Press the star (*) key.
4. Enter the station number and, if necessary, the bed number.
•
A short chirping tone confirms connection. (An error tone sounds if the station is
busy. Go to step 6.)
•
The station’s CANCEL LED and pillow speaker LED (if present) illuminate to in
-
dicate connection.
5. Talk to the person through the handset.
6. To end your telephone session, press the pound (#) key twice to disconnect from the
Telco. A brief warble tone confirms disconnection.
—CAUTION—
You must press the pound (#) key TWICE to disconnect from the Telco. If you do
not, the Telco will be unusable until it times out.
Note:
If your facility has the newer Telco card (Model 110-3628B) and a PBX that supports the
Call Party Disconnect feature (loop drop), you do not need to press the pound (#) key
twice. You can simply hang up the phone.
ProCare 6000 Operation Manual 5-3
Placing a Call from a Telephone