Specifications

Locating a Station in Distress

Press the ZONE pushbutton to exit zone monitoring, if in operation, then press each

remote station button sequentially while pausing briefly to monitor the activities of

each station.

Monitoring Notes:

— You can talk to remote stations in the monitored zone by removing the handset

from the cradle and speaking into the handset. Return the handset to its cradle

when finished; zone monitoring is automatically canceled.

— Incoming calls annunciate normally during monitoring. Answer the call by

pressing the ZONE button to cancel zone monitoring, then pressing the

numbered button next to the flashing LED (or lifting the handset and pressing

the numbered button next to the flashing LED).

— Incoming audio can be adjusted during monitoring. (See Volume Level

Control on page 13.)

The handset on the master station can be used to page one zone or all remote stations

in the system capable of receiving audio. The optional paging equipment must be

present in the system, and the master station must be programmed for the paging

functions.

Paging All Stations

1. Remove the handset from its cradle.

2. Press the ALL PAGE pushbutton. The LED next to the ALL PAGE pushbutton

lights.

3. Make the page announcement using the handset.

4. Return the handset to its cradle or press the ALL PAGE pushbutton again when

finished making the page. The LED next to the ALL PAGE pushbutton goes out.

Paging a Zone

1. Remove the handset from its cradle.

2. Press the ZONE pushbutton. The LED next to the pushbutton lights.

3. Press any remote station pushbutton within that zone. The LEDs of all remote sta-

tions in that zone will light (see Monitoring Notes above).

ProCare 2000 Operation Manual

Paging

(Monitoring)