Specifications

Up to eight preassigned zones, with up to 10 remote (patient, staff, and staff/duty) audio

stations in each zone, can be monitored from the master station. During monitoring, the

LED indicators of the monitored stations light on the master station. The privacy LED

lights on the remote stations being monitored. The volume level of the incoming audio

can be adjusted at the master station (see Volume Level Control below).

Volume Level Control

Incoming audio can be adjusted during monitoring by rotating the volume control on

the left side panel of the master station until the sound coming through the speaker is

at the desired level.

Note:

This adjustment has no effect on the handset volume.

Monitoring a Remote Station

1. To monitor a remote station, press the pushbutton corresponding to the desired re-

mote station. The remote station LED on the master station lights. The red privacy

LED on the patient (or staff, or staff/duty) station also lights.

2. Use either the handset or the microphone/speaker to monitor the station.

3. Return the handset to its cradle or press the remote station pushbutton again to end

monitoring.

Monitoring a Zone of Remote Stations

1. Make sure the handset is in its cradle.

2. Press the ZONE pushbutton.

3. Press the numbered button of any remote station in the zone you wish to monitor.

This lights the LEDs of all remote stations in that zone. You will now hear audio

from all of these stations through the microphone/speaker.

4. Press ZONE again to end zone monitoring.

ProCare 2000 Operation Manual

Monitoring