Instruction manual

EFKA DA82GA3312
16
3.7.1 Programming Mode
 Each seam pattern is programmed and stored separately.
 Exit the teach-in mode after pattern input.
 The values are saved when you start sewing.
Display configuration:
3 Program number (1...8)
04 Seam number (0...40)
020 Stitches for a seam with stitch counting (0...254) 
008 Stitches after light barrier sensing (0...254)
Programming:
After power On without code number input !
1
LC display is cleared 
Display of a parameter
2
at the operator level 
Lefthand arrow above key 0 blinks.
3
Entry into pattern and seam programming. 
4
Changing the pattern number 
The seam functions (e.g. sewing foot lift, start backtack, etc.) can be programmed using the keys on the control panel.
3.7.2 Seam with Stitch Counting
↓
↓↓
↓
Lefthand arrow above key 2 On;
stitch counting is On; 
actual number of stitches is displayed.
3.7.3 Backward Seam with Stitch Counting
↓
↓↓
↓
Righthand arrow above key 2 On;
backward sewing is On; switch to 
forward sewing by pressing the key again.
When sewing backward, all sewing operations including backtack are performed in reverse feeding direction. The functions
"light barrier seam" and "backward seam" block each other, i.e. the light barrier cannot be enabled if the backward seam
has been selected, or, backward sewing is not possible if the light barrier is enabled.
Change the number of stitches using the +/- keys,
or execute the seam section using the pedal !
3.7.4 Stitch Counting and/or Light Barrier
↓
↓↓
↓
Light barrier covered/uncovered On;
actual number of compensating stitches 
is displayed.
3 04 020 008
P
E
aaa bbb
0 1 01 - - -
0 2 01 - - -
2 2 01 004
2 2 01 004
+
-
3 2 01 004 007