Operating instructions

Set-up instructions
Operating manual H867 Version 00.0 - Last updated: 01/2012 41
8.14 Electrical connection
8.14.1 Fitting the sewing lamp
The sewing lamp is an additional component that is not part of the stan-
dard delivery package.
• Unscrew the cover on the machine arm and the upper machine cover
(see Section 8.13 Fitting the control panel).
The upper machine cover has pre-drilled holes for attaching the sewing
lamp.
Figure 45: Fitting the sewing lamp
• Either drill through the hole for 1 large hole (1) or through the holes for
2 small holes (2).
• Screw the sewing lamp holder through the hole on the arm cover.
• Install the connecting cable in the machine arm and guide the cable
through the hole in the table plate (see Section 8.13 Fitting the control
panel).
• Stick the sticker with safety instructions onto the front of the control.
Danger to life due to electric shock.
The machine may only be connected by trained
specialists.
Disconnect the power plug before carrying out
work on the electrical equipment.
The voltage on the type plate of the sewing drive
must correspond to the mains voltage.
DANGER
Danger to life due to electric shock.
When you disconnect the sewing machine from the
power supply at the main switch, the supply volt-
age for the sewing lamp remains active.
Disconnect the power plug before connecting the
sewing lamp.
DANGER
q
w
(1) - Large hole
(2) - 2 small holes