Operating instructions

Set-up instructions
Operating manual H867 Version 00.0 - Last updated: 01/2012 35
8.5 Completing the table plate
Making your
own table plate
The table plate belongs to the optional delivery scope. If you want to make
your own table plate, drawings with the dimensions are available in the
Appendix.
Figure 34: Completing the table plate
• Screw the drawer (5) with the left-hand bracket to the underside of the
table plate.
• Screw the oil pan (4) in place under the recess for the machine.
• Screw the cable duct (7) to the underside of the table plate.
• Insert the thread reel holder (1) in the hole.
• Fasten the thread reel holder (1) with nut and washer.
• Screw the thread real holder and the unwinding bracket onto the
thread reel holder (1) in such a way that they are exactly opposite
each other.
• Insert the plug (2) in the hole.
• Insert the rubber mounts of the hinge in the recesses (6).
• Insert the rubber corners in the corner protrusions (3) of the recess for
the machine.
q
w
e
r
t
y
u
(1) - Thread reel holder
(2) - Hole in the table plate
(3) - Corner projections
(4) - Oil pan
(5) - Drawer
(6) - Recesses for the rubber mounts of
the hinge
(7) - Cable duct