Operating instructions

Set-up instructions
34 Operating manual H867 Version 00.0 - Last updated: 01/2012
8.2 Removing the transport securing devices
All transport securing devices must be removed prior to set-up.
• Remove the lashing straps and wooden blocks from the machine
upper section, the table and the frame.
• Remove the supporting wedges between the machine arm and needle
plate.
8.3 Fitting the frame components
Figure 32: Fitting the frame components
• Screw the cross bars (4) onto the frame bars (3).
• Screw the oil can holder (8) at the rear to the upper cross bar (4).
• Screw the cross strut (6) onto the foot struts (5).
• Insert the inner bars (2) in such a way that the longer end of the head
section (1) is above the longer end of the foot struts (5).
• Screw the inner bars (2) tight in such a way that both head sections (1)
have the same height.
• Turn the adjusting screw (7) in such a way that the frame has even
contact with the ground.
8.4 Fitting the pedal
Figure 33: Fitting the pedal
• Place the pedal (1) on the cross strut (2) and align it in such a way that
the middle of the pedal is subsequently under the needle.
• Screw the pedal (1) firmly onto the cross strut (2).
q
q
i
w
w
e
e
r
r
t
t
y
u
(1) - Head sections of the
inner bars
(2) - Inner bars
(3) - Frame bars
(4) - Cross bars
(5) - Foot struts of the frame
(6) - Cross strut
(7) - Adjusting screw
(8) - Holder for the oil can
q
w
(1) - Pedal
(2) - Cross strut