Operating instructions

Operating instructions
18 Operating manual H867 Version 00.0 - Last updated: 01/2012
• Switch on the sewing machine.
• Press the foot pedal forwards.
The machine sews and winds the looper thread from the thread reel onto
the bobbin.
When the bobbin is full, the machine automatically stops winding. The
bobbin lever moves down.
The cutter is automatically moved into its basic vertical position.
• Pull off the full bobbin.
• Tear off the thread behind the cutter.
• Insert a full bobbin in the looper (see Section 7.6 Replacing the looper
thread bobbin).
• Repeat the winding-on procedure with an empty bobbin, as described
above.
7.6 Replacing the looper thread bobbin
Figure 11: Replacing the looper thread bobbin
• Lift the looper flap (1).
• Remove the empty bobbin.
• Insert a full bobbin: insert the bobbin in such a way that it moves in the
opposite direction of the looper.
• Guide the looper thread through the 1st looper slot (2).
Damage to the sewing feet or needle plate possible if the
thread is wound on without material.
Lock the sewing feet in place in the highest position and adjust the
sewing foot stroke to the smallest value if you wind on thread with-
out sewing material.
ATTENTION
Risk of injury by the needle point and moving
parts.
Switch off the sewing machine before replacing the
looper thread bobbin.
WARNING
w
e
r
t
q
(1) - Looper flap
(2) - 1. looper slot
(3) - Looper spring
(4) - Looper flap guide
(5) - 2. looper slot