Instruction manual

6.1.3.3 DC1550/DA321G drive
Parameter change for machines with gear rate of 28/28 teeth
Parameter Original value New value Parameter description
290* 0 3 Class of the machine
111 - - Max. sewing speed
170 - - Reference position
Parameter change for machines with gear rate 18/28 teeth
Parameter Original value New value Parameter description
290* 0 4 Class of the machine
111 - - Max. sewing speed
170 - - Reference position
* The parameter must be entered first.
Attention:
To set up parameters higher than 200, it is necessary to enter the
control in the programmer’s level (via 3312 code). This allows also
entering parameters lower than 200.
22