Instruction manual

4.3 Fitting the belt guards

–

Disassembly the hand wheel (1).

–

In the machines with the motor on the table top mount the guard (2)

on the machine head (the guard is included in the set of parts for

motor) and mount the guard (3) on the motor (the guard is included

in the motor package).

–

In the machines with the motor on the machine head mount the

guard (4) (is included in the set of parts for motor).

–

Mount the hand wheel (1). Doing this, observe the correct angle

position: if the needle is in the upper dead point, there should be

the 0° value on the hand wheel scale.