Instruction manual

3.2 Assembly of stand table top
3.2.1 Assembly of stand table top in the machine with the motor on the stand table top
–
Turn the table top (1) upside down.
–
Screw the drawer (2).
–
Put the oil tank (3) on the recess in the table top and slide it in the
arrow direction (4) till the relevant protrusions of the tank are
seated on the recess contour. Screw the tank.
–
Screw the drive (5).
–
Screw the sewing lamp transformer (6) – if there is any.
–
Screw the cable clip (7).
–
Screw the electric cable channel (8).
–
Screw the switch (9).
–
Mount electric cables according to par. 5 of this instruction.
–
Pre-bore the holes (10) for wood screws and screw the stand
frame. Then turn the stand to normal position.
–
Mount the yarn stand (11) with the bar orientation according to the
picture.
–
Insert the machine head support pin (12).
–
Screw the rubber hinge bottoms (13).
–
Insert inclined bases (14) in the sockets in the recess corners.
–
Insert the rubber corners (15).
–
Remove the blinds from the bushing (16).
–
Dismantle the knee lever (17) and push it through the bushing (16)
according to the picture.
5
GB
328
28
80
140
770
30
50
185
15
96
368
80
15
110 7 69 58 4 3 10 2
260
11
15
14
12
13
16
17