Instruction manual

EFKA AB221A/AB321A + AB222A/AB322A (BA)
84
If there is not yet a numbered file on the Memory Stick, the control automatically creates file number 00. If there is a
numbered file on the Stick, the next higher number will be used.
Any other file number available on the Stick can also be selected using key + / -, but in this case the file number will be
overwritten, and any previous file content is lost.
The control can manage a maximum of 99 Memory Stick files. When this max. number is exceeded, the error message
»A500 = Max. number of files (99) on MemoryStick exceeded« will be displayed.
On principle, filenames can be freely specified and/or overwritten on the PC, as long as the 3-digit filename extension is
maintained. When downloading files into the control, complete filenames can be shown on the V850 display, whereas
shorter filenames (digits, see above) are to be preferred if using the control display.
Important note:
The control does not identify files saved in folders. It can only identify files that are saved directly on the Memory Stick!
10.2 USB Parameters
The following parameters are available for reading out, storing, comparing or deleting data:
Parameter
Parameter Settings
510 Transfer from control to Memory Stick
511 Transfer from Memory Stick to control
512 Comparison between control and Memory Stick
513 Delete file from Memory Stick
Array Data (Compiler Programming)
514 Transfer from control to Memory Stick
515 Transfer from Memory Stick to control
516 Comparison between control and Memory Stick
517 Delete file from Memory Stick
Seam Pattern (Teach In )
518 Transfer from control to Memory Stick
519 Transfer from Memory Stick to control
520 Comparison between control and Memory Stick
521 Delete file from Memory Stick
Compiler Program
523 Transfer from Memory Stick to control
Control Software (Software Update / Flash Memory)
526 Transfer from control to Memory Stick
527 Transfer from Memory Stick to control
528 Comparison between control and Memory Stick
529 Delete file from Memory Stick
10.3 Storing Data on the Memory Stick
When connecting the Memory Stick to the control, the following message appears on the display:
Control: Usb
V810: USb On
V820: USb dEtEct
V850: USB DETECT
A code number does not have to be inputted; the control is automatically available for programming via Memory Stick. The
parameter number may be inputted immediately.
Storing data (including parameters) on the Memory Stick will be explained in the following