Instruction manual

EFKA AB221A/AB321A + AB222A/AB322A (BA)

Function “Blow Fabric onto Stack”

Function with or without control panel Parameter

Function “blow fabric onto stack” (bLA) 194

ON period for output M7 (kt5) 289

194 = 0 Blow fabric onto stack (output M7) at the seam end over the time (kt5), which can be set using parameter 289.

194 = 1 Blow fabric onto stack (output M7) from light barrier uncovered to seam end; after the seam end over the time

(kt5).

See also chapter “Timing Diagrams“ in the List of Parameters.

9.30 Manual Tape Cutter/Fast Scissors

Upon pressing an external key depending on the pre-selection of parameters 240...249, the tape cutter or fast scissors can

be enabled anywhere in the seam or at standstill.

See also chapter "Connection Diagram" in the List of Parameters!

9.31 Manual Stacker

Function with or without control panel Parameter

Stacker function with open/closed key (iS1) 264

ON period for manual stacker (ktS) 265

After pressing the key that has been allocated for the purpose, a stacker signal will be issued for a certain period of time

(parameter 265) at output M7 (socket ST2/23). Select the key using one of parameters 240...249. The manual stacker

function is possible in all modes except mode 16.

240...249 = 26 Allocation of the key for the manual stacker signal.

264 = 0 Signal “manual stacker” (output M7), when key is closed.

264 = 1 Signal, “manual stacker” (output M7), when key is open.

265 ON period of manual stacker signal.

9.32 Selection of Signals M8, M9 and M10 at the Start of the Seam

Function with or without control panel Parameter

Signals M8, M9, M10 On/Off (0 = Off / 1 = On) (ASi) 273

Delay time for signal M8 at the start of the seam (Ad1) 274

Signal M8 ON period at the start of the seam (At1) 275

Delay time for signal M9 at the start of the seam (Ad2) 276

Signal M9 ON period at the start of the seam (At2) 277

Delay time for signal M10 at the start of the seam (Ad3) 278

Signal M10 ON period at the start of the seam (At3) 279

Three different signals (M8, M9, M10) can be programmed for various applications at the start of the seam. These can be

enabled and disabled using parameter 273. Select delay times and ON periods using parameters 274...279.

9.33 Seam with Stitch Counting

Function without control panel Parameter

Stitch counting On/Off 015