Instruction manual

EFKA AB221A/AB321A + AB222A/AB322A (BA)
45
Display of the 1st parameter value
of position 1 (B key) 
If necessary, change parameter value
... by pressing keys +/- or 0...9 or 
by turning the handwheel (> 1 rotation).
Parameter value of position 2
appears on the display 
If necessary, change parameter value
... by pressing keys +/- or 0...9 or 
by turning the handwheel (> 1 rotation).
Parameter value of position 1A
appears on the display 
If necessary, change parameter value
... by pressing keys +/- or 0...9 or 
by turning the handwheel (> 1 rotation).
Parameter value of position 2A
appears on the display 
If necessary, change parameter value
... by pressing keys +/- or 0...9 or 
by turning the handwheel (> 1 rotation).
Settings are completed. 
Exit programming.
Note
When setting the positions by turning the handwheel, make sure that the displayed numerical value changes.
 The display unit of the set position values is “degrees“.
8.10 Display of the Signal and Stop Positions
Function with or without control panel Parameter
Display of positions 1 and 2 (Sr3) 172
The position settings can easily be checked by means of parameter 172.
 Select parameter 172
 The control panel display shows "Sr3"
 Turn handwheel according to the direction of motor rotation
Control display (control panel not connected)
 Segment  on corresponds to position 1
 Segment
 turns off corresponds to position 1A
 Segment
 on corresponds to position 2
 Segment
 turns off corresponds to position 2A
V810/V820 control panel display
 Arrow above symbol "position 1" on key 4 (V810) / on key 7 (V820) is displayed corresponds to position 1
 Arrow above symbol "position 1" on key 4 (V810) / on key 7 (V820) is displayed corresponds to position 1A
 Arrow above symbol "position 2" on key 4 (V810) / on key 7 (V820) is displayed corresponds to position 2
 Arrow above symbol "position 2" on key 4 (V810) / on key 7 (V820) is displayed corresponds to position 2A
If the V810 or V820 control panel is connected, the positions will be displayed only on the control panel!
0 P1E XX
X
9
»
P1E 140
0 P2E XX
X
9
E
P2E 460
0 P1A XX
X
9
E
P1A 080
P P
4000 Ab220A
0 P2A XX
X
9
E
P2A 400