Instruction manual

EFKA AB221A/AB321A + AB222A/AB322A (BA)

8 Setting the Basic Functions

8.1 Direction of Motor Rotation

Function with or without control panel Parameter

Direction of motor rotation (drE) 161

161 = 0 Clockwise motor rotation (look at the motor shaft)

161 = 1 Counterclockwise motor rotation

8.2 Use of a HSM001 Hall Sensor Module or IPG... Pulse Encoder

Representation and installation of a HSM001 Hall sensor module or

IPG... pulse encoder

Representation and installation of a HSM001 Hall sensor module or

IPG... pulse encoder together with a LSM002

light barrier module by means of adapter cord no. 1113229

Operation with HSM001 Hall sensor module Operation with IPG... pulse encoder

 - Get machine to the needle-up position.

- Position bore for magnet such that the

magnet is located approx. 15° after the

sensor in the sense of rotation.

- Get machine to the needle-up position. 

- Turn disk in the pulse encoder such that the

leading edge will be located approx. 15°

after the sensor on the board in the sense of

rotation.

ATTENTION

If the motor is mounted differently, e. g. at a different angle or with gear, make sure

that the value set using parameter 161 corresponds to the direction of rotation.