Instruction manual

EFKA AB221A/AB321A + AB222A/AB322A (BA)
34
Functions Parameter
Call-up of the Fast Installation Routine SIR (Sir) 500
Setting on the V810 control panel:
 Input code number 3112!
 Press the E key  The lowest parameter 2.0.0. appears at this level
 Select 500  Parameter 5.0.0. is displayed
 Press the E key  Character [o] appears blinking
 Press the >> key  Parameter 2.9.0. appears (functional sequence “trimming operations”)
 Press the E key  Parameter value 05 appears
 Press the +/- key  Parameter value can be changed
 Press the E key  Parameter 1.6.1. appears (direction of motor rotation)
 Press the E key  Parameter value 1 appears
 Press the +/- key  Parameter value can be changed
 Press the E key  Parameter 2.7.2. appears (transmission ratio)
 Press the E key  Parameter value 100 appears
 Press the +/- key  Parameter value can be changed
 Press the E key 
Parameter 2.7.0. appears (type of position sensor)
 Press the E key  Parameter value 0 appears
 Press the +/- key  Parameter value can be changed
 Press the E key  Parameter 4.5.1. appears (position 1 leading edge; position 1 trailing edge
is automatically set at 60°)
 Press the E key  Parameter value appears
 Press the +/- key  Parameter value can be changed
 or turn the handwheel  Set position after min. 1 rotation
 Press the E key  Parameter 4.5.3. appears (position 2 leading edge; position 2 trailing edge
is automatically set at 60°)
 Press the E key  Parameter value appears
 Press the +/- key  Parameter value can be changed
 or turn the handwheel  Set position after min. 1 rotation
 Upon pressing the E key once more the program returns to parameter 290
 Press the P key twice  Exit SIR routine
Setting on the V820 control panel:
 Input code number 3112!
 Press the E key  The lowest parameter 2.0.0. appears at this level
 Select 500  Parameter 5.0.0.
is displayed
 Press the E key  Character [o] appears blinking
 Press the >> key  Parameter 290 FAm 05 appears (functional sequence “trimming operations”)
 Press the +/- key  Parameter value can be changed
 Press the E key  Parameter 161 drE 1. appears (direction of motor rotation)
 Press the +/- key  Parameter value can be changed
 Press the E key  Parameter 272 trr 100 appears (transmission ratio)
 Press the +/- key  Parameter value can be changed
 Press the E key  Parameter 270 PGm 0 appears (type of position sensor)
 Press the +/- key  Parameter value can be changed
 Press the E key  Parameter 451 appears (position 1 leading edge; position 1 trailing edge
is automatically set at 60°)
 Press the +/- key  Parameter value can be changed
 or turn the handwheel  Set position after min. 1 rotation
 Press the E key  Parameter 453 appears (position 2 leading edge; position 2 trailing edge
is automatically set at 60°)
 Press the +/-
key  Parameter value can be changed
 or turn the handwheel  Set position after min. 1 rotation
 Upon pressing the E key once more the program returns to parameter 290
 Press the P key twice  Exit SIR routine