Instruction manual

EFKA AB221A/AB321A + AB222A/AB322A (BA)
32
Functions Parameter
Sewing foot lifted after power On, or as programmed (FLn) 323
This function is active only if TEACH IN is On.
323 = 0 After power On, the sewing foot lift function works as programmed.
323 = 1 The sewing foot is always lifted after power On, even if automatic sewing foot lift is not programmed.
Functions Parameter
TEACH IN On/Off (ti) 324
Using this parameter, TEACH IN can be enabled and disabled without control panel. However, TEACH IN programming
is possible only with the V820 control panel.
When the V820 is connected, TEACH IN is enabled and disabled using key 0.
Functions Parameter
Erasing all TEACH IN data (cti) 325
 Input code number 3112 after power On  Press the E key
 Input parameter 325  Press the E key
 Input 3112  Press the P key
 The display briefly shows “deleted“, and a short acoustic signal is issued.  Press the P key
 All TEACH IN programs have been erased!  Press the P key
 The sewing process is enabled again.
 If you press key 0 now, the display shows “no ProG“
5.6.8 Disabling the Keys on Control Panel V820 with Activated TEACH IN
292 = 0 Keys 1...0 are disabled.
293 = 0 The F1 key is disabled.
294 = 0 The F2 key is disabled.
326 = 0 The P and E keys are Off (no programming, no switching from one seam to the next).
326 = 1 The P key is On and the E key is Off (programming enabled; switching from one seam to the next disabled using
the E key).
326 = 2 The P key is Off and the E key is On (programming disabled; switching from one seam to the next enabled using
the E key).
326 = 3 The P and E keys are On.
Disable switching from one pattern to the next at the seam start using keys + und –.
327 = 0 Keys + and – are disabled (switching from one pattern to the next impossible).
327 = 1 Keys + and – are enabled.