Instruction manual

EFKA AB221A/AB321A + AB222A/AB322A (BA)
30
5.6.4 Inserting a Seam or Pattern
A pattern or seam can be inserted using the A “INSERT F1“ key, on condition that the symbol above the pattern or seam
number is blinking during programming.
 Select the pattern or seam number where the new number is to be inserted. The symbol above the pattern or seam
number must be blinking. Proceed as shown in chapters “Programming with or without Code Number Input“.
 Press the A “INSERT F1“ key twice in brief succession. The new pattern or seam number will be inserted. All
subsequent numbers are automatically augmented by “1“. The following example shows how a seam is inserted before
an existing seam.
KL2390
INSERT F1
KL2391
INSERT F1
KL2392
3 sec.
KL2393
 Any desired function can now be assigned to the new seam.
5.6.5 Deleting a Seam or Pattern
A pattern or seam can be deleted using the B “DELETE F2“ key, on condition that the symbol above the pattern or seam
number is blinking during programming.
 Select the pattern or seam number to be deleted. The symbol above the pattern or seam number must be blinking.
Proceed as shown in chapters “Programming with or without Code Number Input“.
 Press the B “DELETE F2“ key twice in brief succession. The pattern or seam number will be deleted. All subsequent
numbers are automatically reduced by “1“. The following example shows how seam number 2 is deleted.
KL2394
DELETE F2
KL2395
DELETE F2
KL2396
3 sec.
KL2393