Instruction manual

EFKA AB221A/AB321A + AB222A/AB322A (BA)
24
The key assignment can be changed as follows:
Display after power on 
Press the P key. 
Press the E key. 
Press the E key several times until the
letter symbol –F– appears. 
(ornamental backtack On/Off)
Press key–. 
(softstart On/Off)
Press the P key. 
The assignment is completed.
The number of softstart stitches can be changed as follows:
Example: change number of stitches from 1 to 3 (softstart function (key 9) is off).
Press key 9 briefly.
The arrow above the key lights up 
(softstart function is On)
Press key +. 
Number of stitches increases.
Display after 3 seconds 
Example: change number of stitches from 1 to 3 (softstart function (key 9) is already on).
Press key 9 for at least 1 sec.
The arrow above the key goes off momentarily 
(softstart function is On)
Press key +. 
Number of stitches increases.
Display after 3 seconds 
These values are saved when you start sewing. They remain in effect even after turning the machine off!
Using parameter 401 is another possibility for immediate storage without having to start sewing.
5.5.2 Further Functions of the V810/V820 Control Panels
 Press key >>  The most significant digit blinks.
 Press key +/- briefly  The blinking digit changes by ±1.
 Keep key +/- pressed  The blinking digit keeps changing its value, as long as the key is
pressed down.
 Press key >> once more  The next digit blinks.
 Press key +/- as above
 Press the E key  The setting is completed.
With the code number and parameter number there is no carry over when changing from 0 to 9 or vice versa. Parameter
values are, however, carried over. Therefore, you can use key +/- to change the value between the minimum and maximum
value.
If the value change is significant, it is better to use key >>. If the value change is insignificant, use keys +/-.
For setting the minimum or maximum value, select the most significant digit using key >>. Then keep pressing key – for
the minimum or key + for the maximum value.
The above description is applicable to both control panels, V810 and V820. Direct input of values is possible with the V820
using keys 0...9.
P
E
c2 002
4000 Ab220A
E
-F- 2
- -F- 1
P
4000 Ab220A
9 SSc 001
+
SSc 003
4000 Ab220A
9 SSc 001
+
SSc 003
4000 Ab220A