Instruction manual

EFKA AB221A/AB321A + AB222A/AB322A (BA)

4.6 Direct Input of Maximum Speed Limitation without Control Panel

The maximum speed of the machine must be limited to the specific level according to the application. Do the setting at the

operator level on the control operator panel.

The actual value is shown on the display and can be changed using key +/- during operation or at intermediate machine

stop.

Important! If the speed is changed, it is saved only after trimming

and when you start sewing again.

4.7 Program Identification on the Control

Function without control panel Parameter

Program number, modification index and identification number display 179

After having selected parameter 179, the following information is successively displayed:

1. Select parameter 179. 2. Press the E key. 3. Press key >>.

Sr5 is displayed. Display of program number

4. Press the E key. 5. Press the E key. 6. Press the E key.

The program modification The identification number The identification number

index is displayed. digits 1 and 2 are displayed. digits 3 and 4 are displayed.