Instruction manual

11.5.2 Connecting the DA321G control unit

–

Plug the cable from the setpoint director device (pedal) into the

B80 socket on the control unit.

–

Plug the motor sensor cable 1 into the B2 socket on the controller.

–

Plug the motor cable 2 into the B41 socket on the controller.

–

Plug the cable leading to the sewing machine into the A socket on

the controller.

–

Route all cables through the cable duct.

–

Plug the cable from the operating panel (if available) into the B776

socket.

–

Plug the cable 3 from the knee switch into the KN19 socket on the

front side.

–

Use the clips 4 to fasten down the cable 3 (only with 869-180322

and 869-280322 ).

KN19