Instruction manual

3.2 Completing the table plate and mounting to the stand
–
Turn over the ta ble pl ate (1).
–
Screw on the cable channel (2).
–
Screw on the setpoint director device (3).
–
Screw on the cable clamp (4).
–
Position the oil collector (5) in direction of arrow (6) so that the
edge of the oil collector is aligned with the table plate edge. Screw
on the oil collector.
–
Screw on the draw er (7) together with its fixtures.
–
Screw on the control unit (8) (the drill holes for the wood screws
are pre-drilled).
–
Screw on the sew ing light transformer (9) ( optional equipment).
–
Mount the electrical cable according to the instructions in
Chapter 5.
–
Mount the ta ble p late (1) to the stand using the wood screws
(B8x35). Drill the holes (10) for the wood screws. Turn the stand so
that it is positioned in its normal position.
–
Put the reel stand (11) into the drilled hole in the table plate.
Fasten with nut and washer.
Mount and align the reel holder and unwinder holder.
These two holders must be positioned on top of each other.
–
Put the support (12) in the drilled hole.
–
Insert the low er hinge section (13) for the machine head into the
space on the table plate (1). Then screw it in.
–
Insert the w edges (14) into the clearance space in the table plate
(for the rubber corners).
–
Insert the rubber corners (15).
–
Remove the plug (16) on the oil collector for the knee lever (17).
–
Remove the knee lever (17) and guide through the opening, as
shown in the illustration.
GB
5
328
30
80
770
72
185
15
368
80
15
4
10 2 69 58 13 10
14
12
15
11
260
13
17
460
180
15
7
50
16
30