Instruction manual

6.2.3 Checking the set positions

1. Position

Turnthemainswitchon.

Step forwards slightly on the pedal and then release. The machine will

stop in the first position (refer to 6.2.1).

The number 225° (± 5°) on the handwheel scale is aligned with the

mark on the arm.

2. Position

First step slightly forwards on the pedal. Then press backwards with

your heel until the machine stops.

The machine will stop in the second position (refer to 6.2.1).

The number 35° (± 5°) on the handwheel scale is aligned with the mark

on the arm.

6.3 Master reset

All changed values will be reset to their pre-set default values after a

master reset is executed.

After a master reset, all machine-specific parameters must once again

be properly set.

This is described in the booklet entitled “Instructions for Efka

Operation”.