Instruction manual

5.1.1 Connecting the sewing light transformer to the supply voltage

Caution Danger of Injury!

The sewing light cannot be turned off with the main switch

(EN 60 204-31)! The mains power supply must be disconnected before

mounting the illumination, repairing the transformer or changing fuses.

–

Pull the plug out of the socket.

–

Loosen the four screws on the front plate of the control c abinet.

–

Take off the front plate.

–

Guide the sewing light transformer cable through the cable duct (1)

into the control cabinet.

–

Take off the black rubber guide track (2).

–

Make a hole in the guide track (2) with a screw driver.

–

Guide the cable for the sewing light transformer through this new

opening.

–

Re-mount the rubber guide track (2).

–

Use a thin screwdriver to press on the terminal openings (3) and

(4). This opens up the terminals (5) and (6).

–

Connect the blue cable to terminal (6) and the brown cable to

terminal (5).

–

Screw the front plate back on.

–

Install a strain relief mechanism (e.g., a cable tie) for the

transformer cable.

26 5 1

65 4 3