Technical data

Set-up instructions
Operating manual 806N Version 00.0 - 12/2012 97
6.5 Setting up/connecting the sewing unit
Follow the steps described here for setting up and connecting the unit.
Damage to the machine and personal injury can only be avoided by fol-
lowing the correct set-up procedure.
6.5.1 Setting up
To prevent accidents the weight of the sewing unit must be evenly distrib-
uted over the 4 adjustable feet.
Correctly align the sewing unit as follows:
1. Place a spirit level on the frame (e.g. at the rear after first removing
the rear lower covers) in order to align the machine level.
2. Release the counternut (1).
Figure 65:
3. Turn the adjustable foot (2) until it reaches the correct height.
4. Tighten the counternut (1) again.
5. Repeat steps 2 to 4 for the other feet.
 The machine is now aligned level.
Risk of injury due to a lack of specialist knowl-
edge
Inadequate specialist knowledge can result in seri-
ous injuries when setting up the machine.
 Allow ONLY trained personnel to set up the
machine.
WARNING
(1) - Counternut (2) - Adjustable

