Technical data

Set-up instructions
96 Operating manual 806N Version 00.0 - 12/2012
Figure 64: Sewing head transport lock
Edge folding
station
The edge folding station is delivered in shape changing mode, even when
no shapes are supplied with the machine.
4. Remove the polystyrene foam from between the protective bar and
edge folding frame at the front of the edge folding station.
5. Remove any fastening tape or cable ties from the carriage of the mid-
dle slide and edge folding frame.
 The edge folding station transport lock has now been removed.
Stacker 6. Remove the fastening tape used for fastening the stacker to the
machine.
7. If necessary, remove the tape from the stacker and pivot the stacker
away from the machine.
 The stacker transport lock has now been removed. The stacker can
now move freely.
Transfer
carriage
8. Remove the fastening tape fastening the transfer carriage to the edge
folding frame and the machine frame.
9. Deactivate the EMERGENCY STOP switch by pulling it out to the left,
 Section 5.10 Emergency procedure.
 The transfer carriage transport lock has now been removed. The
transfer carriage can now move freely.
Power cable/
foot switch
The power cable and foot switch are already fitted to the machine.
Remove both items from the machinery space behind the controller.
Remove the rear cover below the table level to make this easier.


(1) - Metal ring (2) - Screw