Technical data

Set-up instructions
94 Operating manual 806N Version 00.0 - 12/2012
Above the table
level
The correct sequence for removing the covers above the table level is as
follows:
Cover (1) - Edge folding station
1. Remove the cover upwards while paying attention to the key panel
guide.
Cover (5) - Carriage
1. Place the cover on the carriage from above.
2. Fit the cover so that it lies on the edge folding station cover (1).
Cover (6) - Sewing head
1. Fit the cover into the guide at the upper right of the carriage (5) cover.
2. Fit the thread reel holder from above.
3. Tighten the clamping lever on the thread reel holder by reaching
under the cover.
4. Lock the cover lock using the associated key.
Below the table
level
The correct sequence for installing the covers below the table level is as
follows:
Cover (9) - Right side
1. Fit the cover downwards into the guide hooks.
2. Pull the cover upwards.
3. Fit the cover upwards into the guide hooks.
 The cover is locked in place by the springs on the lower guide hooks.
4. Fit the plate.
5. Fasten the plate with the screws.
Cover (2) - Left side
1. Fit the cover downwards into the guide hooks.
2. Pull the cover upwards.
3. Fit the cover upwards into the guide hooks.
 The cover is locked in place by the springs on the guide hooks.
4. Slide the retaining bar into the guide.
5. Fasten the screws on the retaining bar.
Cover (10) - Left and right rear
1. Fit the cover downwards into the guide hooks.
2. Pull the cover upwards.
3. Fit the cover upwards into the guide hooks.
 The cover is locked in place by the springs on the guide hooks.