Technical data

Set-up instructions
Operating manual 806N Version 00.0 - 12/2012 93
Cover (7) - Front right
1. Release the screw using a hey key through the hole.
2. Pull the cover upwards.
3. Remove the cover forwards.
Cover (2) - Left side
This cover does not normally need to be removed. Everything inside the
machine is accessible when the rear covers below the table level are
removed.
1. Release the screws on the retaining bar.
2. Pull put the retaining bar.
3. Pull the cover upwards.
4. Remove the cover forwards.
Cover (9) - Right side
1. Release the screws.
2. Remove the plate.
3. Pull the cover upwards.
4. Remove the cover forwards.
Cover (8) - Stacker
1. Pivot the stacker towards the machine.
2. Remove the inner earthing cable from the cover.
3. Release the hex screw at the outer right of the cover.
4. Release the hex screw at the outer left of the cover.
5. Remove the cover forwards.
6.3.2 Installing covers
Material damage due to incorrect sequence.
The covers above the table level can be damaged when removed/
installed in the incorrect sequence.
 ALWAYS remove/mount the covers above the table level in the
specified sequence.
ATTENTION
Material damage due to incorrect sequence.
The covers below the table level can be damaged when the snap-
locks/springs are not correctly fastened.
 The snap-locks/springs for the covers below the table level must
ALWAYS be correctly latched in place.
ATTENTION