Technical data

Set-up instructions
92 Operating manual 806N Version 00.0 - 12/2012
Figure 63: Covers on the rear side of the machine
Above the table
level
The correct sequence for removing the covers above the table level is as
follows:
Cover (6) - Sewing head
1. Unlock the cover lock using the associated key.
2. Release the clamping lever on the thread reel holder by reaching
under the cover.
3. Pull out the thread reel holder upwards.
4. Slide the thread regulator clockwise.
5. Lift the cover upwards.
Cover (5) - Carriage
1. Remove the cover upwards.
Cover (1) - Edge folding station
1. Remove the cover upwards while paying attention to the key panel
guide.
Below the table
level
The correct sequence for removing the covers below the table level is as
follows:
Cover (10) - Left and right rear
1. Pull the cover upwards.
2. Remove the cover forwards.
Cover (4) - Front left
1. Pull the cover upwards.
1. Remove the cover forwards.
(9) - Right side cover (10) - Left and right rear covers

