Technical data

Operating instructions
Operating manual 806N Version 00.0 - 12/2012 79
• The machine enters the Safe stop mode.
• The sewing head is raised.
Proceed as follows to continue sewing after a thread breakage:
1. Thread the needle thread again,  Section 5.2.4 Threading the
needle thread..
2. Press the Start button.
 The Start button flashes green and the Safe stop mode is switched
off. The machine automatically moves somewhat before the position
of the thread breakage. The sewing head lowers in this position.
 The following message is displayed on the operating terminal:
Figure 53: Message after thread breakage
3. Use Manual button 1 to move stitch-by-stitch, or press it longer, to
move to the thread breakage position.
4. Press the Start button.
 The sewing cycle is started anew at the position of the thread break-
age and the seam is then sewn normally to the end.
5. If the product has been moved too far beyond the thread breakage
position: Keep pressing so that the machine moves completely
around once OR proceed as described below under "do not continue
sewing".
If you do not wish to continue sewing after a thread breakage:
1. Press the Cancel button.
 The machine moves into the basic position.
2. Pull the material to be sewn a short distance out of the sewing area
and cut the hook thread.
3. Completely remove the material to be sewn.
4. Start a new sewing cycle.