Technical data

About this operating manual
6 Operating manual 806N Version 00.0 - 12/2012
Information
notes
Content of information notes
Information notes are identified by a black line above or below the refer-
ence text.
Information notes provide you with information on facilitating the operating
procedure and about the accessories or similar.
There are no negative effects if these notes are not read.
Safety Important warnings for the user of the machine are specifically marked.
Because safety constitutes an area of major importance, hazard symbols,
levels of risk, and their signal words are described separately in
 Section 3 Safety instructions.
Location
information
Information on where something is positioned using the terms "right" or
"left" must always be regarded from the operator's point of view if the
figure gives no other obvious indication for determining the location.
1.4 Other documents
The device contains built-in components from other manufacturers. The
respective manufacturers have carried out hazard assessments for these
purchased parts and confirmed compliance of the design with the applica-
ble European and national regulations. The intended use of the built-in
components is described in the corresponding manuals of the manufac-
turers.
1.5 Liability
All information and notes in this operating manual have been compiled in
accordance with the latest technology and the applicable standards and
regulations.
The manufacturer cannot be held liable for any damage due to:
• Damage during transport
• Failure to observe the operating manual
• Improper use
• Unauthorized modifications to the machine
 The result will be
a correct seam.
After you have performed the step, the result is written in ital-
ics.
Highlighting Designations of surfaces, selection windows, or buttons
used in the software and keys on the machine are high-
lighted in bold type.

References to further information in this operating manual or
other documents are identified by this symbol.
Symbol/character Meaning