Technical data

Operating instructions
72 Operating manual 806N Version 00.0 - 12/2012
4. Press the Confirm button to confirm the entered value.
 The selection window closes and the entered value is displayed in the
field above the Outfeed roller path button.
5. Press the Exit button to correct the entered value.
 The entered value is deleted.
6. Press the Exit button again to exit the selection window.
 The selection window closes and you are returned to the Menu 2
screen.
This setting remains stored after switching off the machine, after loading
a different seam program or after an EMERGENCY STOP.
Suitable value
With settings 2-10 it is not possible to specify a concrete distance or rota-
tion value for the outfeed roller. The correct value must be tested depend-
ing on the requirements and material used.
5.7.9 Activating the advance roller
The advance roller is an optional extra. It is required when the sewn prod-
ucts are so short that the standard outfeed roller cannot reach them in the
sewing area.
The advance roller path cannot be set. It rolls the finished product forward
until it can be reached by the outfeed roller. This interplay is made possible
through the use of a light barrier.
You activate the advance roller as follows:
1. Navigate to Menu 2.
2. Press the Advance roller button .
 The button is now highlighted in green. In the next sewing cycle the
advance roller transports the finished product to the outfeed roller.
3. Press the Advance roller button again to deactivate this mode.
 The button is no longer highlighted in green. The advance roller is no
longer active in the next sewing cycle.
This setting remains stored after switching off the machine, after loading
a different seam program or after an EMERGENCY STOP.