Technical data

Operating instructions
Operating manual 806N Version 00.0 - 12/2012 71
No stacking Note that sewn products can only be stacked when a stacker is actually
present. If you have only deactivated a stacker this does not automatically
activate the other stacker.
This setting remains stored after switching off the machine, after loading
a different seam program or after an EMERGENCY STOP.
5.7.8 Setting the outfeed roller path
This allows you to set the path over which the finished sewn product is to
be rolled before being ejected from the sewing area. Three outfeed roller
variants can be set:
You set the roller path as follows:
1. Navigate to Menu 2.
2. Press the Outfeed roller path button .
 The following window appears:
Figure 46: Outfeed roller path selection window
3. Enter the roller path to be used for rolling out the finished sewn prod-
ucts by pressing the buttons (value between 0 and 10).
 The entered value appears in the input field above. With a value of "0"
the button in Menu 2 is not highlighted in green, with values between
"1" and "10" the button is highlighted in green.
Value Function
0 The outfeed roller is switched off and does not roll.
1 The outfeed roller is switched on and only rolls the finished sewn prod-
ucts for ejection from the sewing area.
2-10 The outfeed roller is switched on and first slowly rolls the finished
sewn products a specific distance out of the sewing area. After this it
ejects the product by rolling it quickly out of the sewing area.