Technical data
Operating instructions
Operating manual 806N Version 00.0 - 12/2012 67
The operation of the Work step-by-step mode is described in detail in
Section 5.3 Carrying out a test run.
This setting is deleted after switching off the machine, after loading a dif-
ferent seam program or after an EMERGENCY STOP.
5.7.2 Activating Sewing without edge folding
In the Sewing without edge folding mode the machine only sews
– the fold-
ing procedure is not performed. This mode can be used for (e.g.) testing
a new seam program or performing a seam quality check.
The speed is also often reduced when using this mode, but this setting
must be specially performed Section 5.7.10 Setting the motor speed.
You activate Sewing without edge folding as follows:
1. Navigate to Menu 2.
2. Press the Sew without edge folding button .
The button is now highlighted in green. In the next sewing cycle the
machine only sews and does not fold. The button is also displayed in
Menu 1.
3. Press the Sew without edge folding button again to deactivate
this mode.
The button is no longer highlighted in green. The machine once more
performs folding in the next sewing cycle.
This setting is deleted after switching off the machine, after loading a dif-
ferent seam program or after an EMERGENCY STOP.
5.7.3 Switching the stroke position on/off
The stroke position is the clearance between the sewing foot and the
seam material. This clearance should be set to the optimum value so that
the seam material is held on the sewing material support when the thread
is tightened. This results in a high quality seam.
Stroke position OFF
The foot always remains at the same distance above the seam material.
An adjustment to suit multi-layered material is not possible.
Stroke position ON
The foot adjusts to suit the thickness of multi-layered seam material.
A prerequisite for this is that the necessary information for this is stored
in the respective seam program.
You switch the Stroke position on/off as follows:
1. Navigate to Menu 2.
2. Press the Stroke position button .
The button is now highlighted in green. When sewing, the machine
automatically adjusts the stroke position according to the information
in the seam program.