Technical data

Operating instructions
Operating manual 806N Version 00.0 - 12/2012 65
Operating You operate the Slide automatically forward mode as follows:
The Start button lights up green and the middle slide is forward.
Be careful to avoid being cut by the sharp edges of the middle
slide.
1. Place the pocket blank on the middle slide.
2. Place and align the basic part on the edge folding station.
3. Fasten the basic part by pressing Manual button 1 or the Foot
switch.
 The air suction is now switched on.
4. Press Manual button 1 to start the normal sewing process. Be care-
ful to avoid being cut or crushed by the slide moving quickly forwards.
5.6.5 Activating the alignment of strips
After folding the pocket blank the machine pulls the middle slide out of the
pocket and stops. The alignment of the pocket blank can now be checked.
Activating You activate the Strip alignment mode as follows:
1. Press the Strip alignment button .
 The button is now highlighted in green. In the next sewing cycle the
machine stops after folding and the alignment of the pocket can be
checked.
2. Press the Strip alignment button again to deactivate this mode.
 The button is no longer highlighted in green. The machine no longer
stops after folding in the next sewing cycle.
This setting remains stored after switching off the machine, after loading
a different seam program or after an EMERGENCY STOP.
Operating You operate the Strip alignment mode as follows:
The machine stops after folding. The finished folded pocket lies
on the basic part.
1. Check the alignment of the pocket on the basic part.
2. If the alignment is correct: Press Manual button 1.
 The sewing procedure is resumed normally.
3. If the alignment is not correct: Press the Cancel button.
 The sewing procedure is cancelled. The basic part and pocket must
be placed again.