Technical data

Operating instructions
Operating manual 806N Version 00.0 - 12/2012 55
5.4 Sewing with default settings
If all aspects in the checklist from  section 5.2 Preparing the machine
for operation are met, then you can begin sewing with the 806N without
making any further settings.
The sewing cycle comprises the following steps:
• Applying the basic part and pocket blank
• Edge folding (folding) the pocket blank
• Transfer of the material to be sewn
• Sewing the material to be sewn
• Rolling out and stacking of the material to be sewn
The operator only has to carry out the first step. The other steps are run
through by the 806N independently.
Risk of crushing due to pneumatic parts.
The use of compressed air produces strong forces
on the moving parts. If your fingers or hands get in
between the parts, this could result in minor to mod-
erate injuries.
 NEVER reach into the area of moving parts.
WARNING
Risk of being cut and stabbed by moving
machine parts.
Serious injuries to any part of the body may occur
if you come into contact with the middle slide, nee-
dle, or other sharp-edged and pointed objects.
 ONLY work on the machine if the secure stop
light is lit up.
 NEVER reach into the area of sharp-edged parts
during operation.
WARNING
Material damage due to pieces of used fabric and threads.
If pieces of used fabric and threads get into the machine, they may
result in damage or defects.
 Immediately remove any obvious contamination during the course
of working.
 Clean the machine after each shift.
ATTENTION