Technical data

Operating instructions
50 Operating manual 806N Version 00.0 - 12/2012
Figure 33: Peg and plastic holder
4. Firmly press the connecting piece (1) on the left side of the transfer
plate and the connecting piece (2) on the left side of the transfer
frame into one another.
 They click into place and the transfer plate is connected to the trans-
fer frame on both sides.
5. Move the transfer plate up and down.
 If the plate is wobbling conspicuously, then the peg is not fixed in the
plastic holder; continue then with step 6. If it is not wobbling, then the
transfer plate is inserted.
6. Use the right thumb or index finger at the rear right corner of the
transfer frame to press the flexible plastic holder downwards until the
peg slides in.
7. Move the transfer plate up and down again to check.
 The transfer plate is correctly inserted if it is no longer wobbling. If it is
still wobbling: Repeat steps 6 and 7.
8. Now insert the hose insert.
(1) - Peg on the transfer plate
(2) - Forked plastic holder

