Technical data

Operating instructions
Operating manual 806N Version 00.0 - 12/2012 49
Step 2:
Inserting
the shaping
assembly
Insert the shaping assembly components in the order specified here.
This is how you achieve a correctly inserted shaping assembly.
Transfer plate This is how you insert the transfer plate:
Figure 31: Aligning the transfer plate
1. Push through the transfer plate, with the metallic lug aligned upwards
to the right (as shown in figure 26), underneath the outfeed roller and
position it underneath the transfer frame.
2. Firmly press the connecting piece (1) on the right side of the transfer
plate and the connecting piece (2) on the right side of the transfer
frame into one another.
Figure 32: Connecting pieces between the transfer frame and transfer plate
 They click into place and the transfer plate is fixed on the right side.
3. Position the peg (1) at the rear right of the transfer plate in the forked
plastic holder (2) to the right, under the transfer frame.
Material damage due to incorrect installation.
If the shaping assembly components are not inserted correctly,
there is a danger that the parts or the machine could get damaged.
 Check that all components in the shaping assembly are securely
fixed.
 If needed, rectify any incorrect seating of the parts.
ATTENTION
(1) - Connecting piece on the transfer frame
(2) - Connecting piece on the transfer plate

