Technical data

Operating instructions
Operating manual 806N Version 00.0 - 12/2012 47
Hose insert Remove the hose insert (806N-121 only) as follows:
Figure 29: Removing the hose insert
1. Remove the edge folding frame and middle slide.
 The hose insert can now be easily reached.
2. Press the hand valve (1) under the table plate using your right hand
and hold it there.
 The hose insert is pushed up on the left side.
3. Raise the hose insert using your left hand and then release the hand
valve (1).
4. Disconnect the hose insert from the compressed air connection. To do
this, push the outer ring of the quick coupling to the rear.
 The compressed air connection is disconnected and the hose insert
can be completely removed.
5. Now remove the transfer plate.
Material damage due to incorrect decoupling.
The compressed air connection could become damaged through
improper decoupling.
 Release the compressed air connection according to the manual.
 NEVER remove the compressed air connection by force.
ATTENTION
(1) - Hand valve
(2) - Hose coupling

