Technical data

Operating instructions
Operating manual 806N Version 00.0 - 12/2012 41
Figure 25: Bobbin and bobbin capsule
Removing the
bobbin
Remove the bobbin as follows:
1. Ensure that the machine is in the Safe stop mode - if not: Press the
Stop button.
2. Grasp the bobbin capsule, located far to the rear and centrally under
the sewing material support, with your left hand.
3. Lift the lever (2) on the bobbin capsule.
 The bobbin capsule is no longer locked in place and can be removed.
4. Remove the bobbin capsule from the hook.
Inserting the
bobbin
Fit the bobbin as follows:
1. Ensure that the machine is in the Safe stop mode - if not: Press the
Stop button.
2. Press the full bobbin into the bobbin capsule so that it moves against
the thread direction when the thread is pulled.
3. Pull the thread through the slot (3) under the spring (1).
 The bobbin is correctly fitted in the bobbin capsule when pulling the
thread to the left causes the bobbin to rotate clockwise.
4. Pull out about 3-5 cm of thread.
5. Grasp the bobbin capsule by the lever (2) and insert it into the hook
under the sewing material support.
 The bobbin is correctly fitted when it clearly latches into place.
6. Enter the number of stitches into the Bobbin menu and accept this
value for the stitch counter,  Section 5.6.2 Setting the bobbin coun-
ter.
7. Press the Exit button to exit the Bobbin menu.
 You are returned to Menu 1.
8. Continue working with the machine.
(1) - Spring (2) - Lever (3) - Slot


