Technical data

Operating instructions
36 Operating manual 806N Version 00.0 - 12/2012
Seam program
cannot be
selected
If no pocket seam program can be selected in the selection window for
the seam program, then this could be due to several reasons.
Remedial action:
• Clean the light sensor on the machine. In the event of contamination,
the code cannot be read correctly.
• Check the code on the rear side of the transfer plate. Are the reflector
strips still complete and in good order?
• Replace the transfer plate or the entire shaping assembly  Section
5.2.6 Fitting/replacing the shaping assembly if the coding of the sew-
ing programs and the transfer plate do not match.
• Load a new pocket sewing program,  Service instructions for the
806N, if the sewing program is not compatible with the transfer plate.
3. Select a pocket sewing program.
Figure 20: Seam program selected
 The selected seam program is highlighted in blue and appears in the
option field.
4. Press the Confirm button to confirm the choice of seam program.
 Menu 1 appears after a delay that depends on the size of the selected
seam program: