Technical data

Performance description
10 Operating manual 806N Version 00.0 - 12/2012
2.4 Additional equipment
The following additional equipment is available for the 806N-121:
Additional equipment Order number
Parts set: Shape-ready edge folding set
Basic pocket shape F1000/1500 0805 929901
Basic pocket shape F2000/2500 0805 929902
Basic pocket shape F3000/3500 0805 929903
Basic pocket shape F4000/4500 0805 929904
For single-piece pockets (with transfer plate - single seam)
Basic pocket shape F1000/1500 0806 929914
Basic pocket shape F2000/2500 0806 929915
Basic pocket shape F3000/3500 0806 929916
Basic pocket shape F4000/4500 0806 929917
Parts set: Shape-ready transfer plate for single seam,
underwear and jeans
0806 929901
Parts set: Shape-ready transfer plate for parallel double seam
with inner slide, underwear
0806 929902
Conversion set for processing single-piece pockets 0806 590034
Parts set: Additional seam (pencil pocket)
Either as a straight stitch seam of any length with a reverse
bar at both ends or a zigzag seam with a maximum length of
12.5 mm.
The width of the zigzag seam corresponds to the stitch length.
One parts set must be ordered for each additional seam.
0805 417609
Parts set: Outfeed roller
For sewn products that are LONGER than 310 mm from the
seam of the attached pocket to the lower edge of the basic
part.
0806 428009
Parts set: Outfeed roller with advance roller
For sewn products that are SHORTER than 310 mm from the
seam of the attached pocket to the lower edge of the basic
part.
0806 428039
Parts set: Semi-finished parts for self-production of the shape-
dependent parts of an edge folding set
0805 417514
Parts set: Semi-finished parts for self-production of the trans-
fer plate for a single seam
0806 417544
Parts set: Semi-finished parts for self-production of the trans-
fer plate for a double seam with inner slider
0806 417554
Parts set: Adapter
To allow attachment of a class 805 transfer plate to a class
806N transfer lever.
0806 417514