Technical data

Packing, transportation
Operating manual 806N Version 00.0 - 12/2012 105
11. Fasten the polystyrene foam between the protective bar and edge
folding frame.
12.If necessary, use tape or cable ties to fasten the middle slide carriage
and edge folding frame.
 The edge folding station components are now fastened for transport.
Stacker 13.Use tape or cable ties to fasten the stacker bar to the stacker.
14.Fold the stacker to the machine and tape it to the frame.
 The stacker is now fastened to the machine.
Transfer
carriage
15.Activate the integrated EMERGENCY STOP switch on the transfer
carriage by pressing it in to the right.
16. Slide the transfer carriage all the way to the left.
17.Tape the transfer carriage to the machine frame and the edge folding
frame.
 The transfer carriage is now secured for transport.
Power cable/
foot switch
The power cable and foot switch are permanently fitted to the machine.
They can be stored in the area behind the controller. Remove the rear
cover below the table level to store the cable more easily.
8.2 Packing the machine
Pack the machine so that it cannot slip or fall over. Use a stable base and
fasten the machine to this. Provide protection from external damage to the
machine.
Risk of injury due to own weight and packaging
materials.
Contact with the packaging materials without
wearing appropriate protective clothing can result
in serious injuries.
 ALWAYS wear gloves and safety shoes when
packing the machine.
 ALWAYS watch out for sharp edges on clamps,
paper and packing straps.
WARNING