Technical data

Packing, transportation
104 Operating manual 806N Version 00.0 - 12/2012
8 Packing, transportation
The aspects relating to packing and transportation are described below.
Keep to the procedure described here to ensure fault-free operation of the
machine.
8.1 Fitting the transport locks
Transport locks must be fitted to the following places in order to protect the
machine from damage during transport:
• Sewing head
• Edge folding station
•Stacker
• Transfer carriage
Fit the transport locks as follows:
1. Depressurize the machine and place it in the Safe stop mode.
2. Remove all covers above the table plate,
 Section 6.3 Removing/installing covers.
Sewing head 3. Press down the sewing head - vent any residual compressed air if
necessary.
4. Release the screws on the metal ring.
5. Fit the metal ring around the sewing head pressure cylinder.
6. Tighten the screws on the metal ring.
 The sewing head transport lock is now installed.
Figure 70: Sewing head transport lock
Edge folding
station
7. Place the machine in the shape changing mode,  Section 5.2.6.
8. Press the EMERGENCY OFF button.
9. Acknowledge the error message and shut down the PC.
10. Switch off the machine at the main power switch.


(1) - Metal ring (2) - Screw