Technical data

Set-up instructions
100 Operating manual 806N Version 00.0 - 12/2012
Figure 68: Connection to the pneumatic system
Connect the compressed air as follows:
1. Connect the connection hose with the hose coupling to the com-
pressed air supply.
2. Plug the connection hose onto the hose neck of the pressure gage
and fasten with a hose clamp.
3. Open the shut-off valve by turning it to the right into the horizontal
position.
Setting the operating pressure
The operating pressure is 6 bar. This can be read on the pressure gage
(1).
To increase
pressure
Pull the twist grip (2) down and turn it clockwise until reaching a pressure
of 6 bar.
To reduce
pressure
Pull the rotary handle (2) down and turn it counter-clockwise until reaching
a pressure of 6 bar.
6.5.5 Topping up the oil
The procedure for topping up the oil in the sewing unit is described in
 Section 5.11.2 Lubrication. The specifications for the oil to be used are
also listed below.
Use only DA10 sewing machine oil or an equivalent oil conforming to the
following specifications:
• Viscosity at 40°C: 10 mm
2
/s
• Flash point: >160°C
DA10 sewing machine oil can be obtained from Dürkopp Adler sales
offices under the following part numbers:
(1) - Pressure gage (2) - Twist grip

